EMERGENCY GAS ENGINEER CALL-OUT — PERTH

GAS APPLIANCE FAULT? GAS SAFE ENGINEER TODAY.

Hob not lighting, oven faulty, gas fire won’t ignite, suspected gas problem with any appliance — EcoGas’s Gas Safe registered engineers diagnose and repair fast, with most call-outs fixed on the first visit.

3 Gas Safe engineers ready to dispatch across Perth

Answered in under 30 seconds

60–90 MIN ARRIVAL
GAS SAFE REGISTERED
NO CALL-OUT FEE
4.9/5 · 134 REVIEWS

GAS APPLIANCE FAULTS ARE NOT ALWAYS THE APPLIANCE

A hob that won’t light isn’t always the hob — sometimes it’s the gas pressure, sometimes a partially blocked jet, sometimes the gas supply to that section of the property. A gas fire that ignites then cuts out usually has a faulty oxygen depletion sensor (ODS). An oven that runs cold can be a failed thermocouple, a worn regulator, or insufficient gas pressure throughout the property.

EcoGas diagnoses gas appliance faults properly — gas pressure measurement, gas tightness testing, combustion analyser readings, visual inspection. We find the actual cause before quoting parts, so you pay for the real fix, not a guess. Every fault corrected leaves your gas safety certification fully intact.

4.9/5 from 134 verified Perth customers

GAS APPLIANCE FAULTS WE FIX

Most diagnosed and repaired in a single visit

GAS HOB WON'T LIGHT

Burners won't light or won't stay lit — usually ignition, partial jet blockage, or gas pressure issue.

GAS OVEN PROBLEMS

Oven won't heat, runs cold, or burns hot — usually thermocouple, regulator, or thermostat issue.

GAS FIRE FAULTS

Gas fire won't ignite, cuts out after a few minutes, or pilot light keeps going out — usually ODS or pilot assembly.

GAS WATER HEATER

Instantaneous water heater not firing, or cycling on and off — usually flow sensor or ignition components.

GAS SMELL NEAR APPLIANCE

Gas smell only near a specific appliance — usually a worn flexible connector or seal failure.

NO GAS TO PROPERTY

Entire property has no gas — usually a meter issue (supplier's responsibility) but we can diagnose first.

ECOGAS'S GAS APPLIANCE CALL-OUT SERVICE

FAST RESPONSE

Gas Safe registered engineer dispatched immediately on call. Full gas testing kit on every van. Most appliance faults diagnosed within 30 minutes of arrival.

PROPER REPAIR

Failed components replaced with manufacturer-spec parts. Full re-testing after repair. Gas Safe documentation issued for your records.

WHAT PERTH SAYS ABOUT OUR GAS CALL-OUTS

Edward T. — Perth

Gas hob suddenly stopped lighting on a Sunday morning. EcoGas was here in 80 minutes, found a partial jet blockage from years of accumulated debris, cleaned all burners, full safety check. Reasonable price for a weekend call-out.

Fiona B. — Perth

Range cooker oven had been running cold for weeks. Two other firms had quoted us for a new oven. EcoGas diagnosed a worn thermocouple — £45 part, fitted in 30 minutes. Oven running perfectly. Honest people.

Graham N. — Perth

Gas fire kept cutting out after 10 minutes — driving us mad. EcoGas identified the oxygen depletion sensor was overdue replacement (designed safety feature on modern gas fires). Replaced the part, full safety check, problem solved.

Hannah C. — Perth

Smell of gas near our gas hob worried us. EcoGas came out fast, gas tightness tested the appliance and supply, found a worn flexible hose connector behind the cooker. Replaced it, re-tested, certified. Peace of mind restored.

HOW IT WORKS

Same EcoGas process, every time

ON-SITE RESPONSE

FIND THE REAL FAULT

FIX IT PROPERLY

GAS CALL-OUT PRICING

Fixed in writing before any parts are fitted

DIAGNOSTIC + MINOR FIX

£85–£160 Diagnosis included. Simple repairs (jet cleaning, sensor replacement) completed same visit.

STANDARD COMPONENT REPAIR

£140–£280Thermocouple, regulator, ignition, valve replacement. Including parts and labour.

MAJOR REPAIR / NEW PART

£250–£480Burner assembly, control valve, oxygen depletion sensor. Quoted after diagnosis.

Every price quoted as a fixed amount in writing before work starts · 12-month workmanship guarantee on every job

GAS APPLIANCE FAULT? CALL NOW

Gas faults are safety issues, not just convenience issues. Gas Safe registered engineers dispatched the second you call.

WHY PERTH CHOOSES ECOGAS FOR GAS CALL-OUTS

GAS SAFE REGISTERED

Every engineer — non-negotiable. Verifiable on the Gas Safe Register.

FAST ARRIVAL

60–90 minute average for emergency call-outs across Perth.

HONEST DIAGNOSIS

Proper testing before quoting — no guess-the-fault upselling.

PARTS ON VAN

Common appliance spares carried — most repairs done first visit.

CERTIFIED AFTER

Full Gas Safe certificate issued for every repair. Records emailed.

12-MONTH GUARANTEE

Workmanship guaranteed for 12 months. Fault recurs, we come back free.

GAS APPLIANCE CALL-OUT FAQS

MY GAS HOB WON'T LIGHT — WHAT'S WRONG?
Common causes: (1) Failed ignition unit (electric click but no spark); (2) Partial jet blockage from years of debris (sparks but no flame); (3) Gas pressure issue (some burners light but others don’t); (4) Failed thermocouple (lights briefly then goes out); (5) Worn or perished flexible connector (whole hob loses gas). We diagnose with proper testing — usually identifying the cause within 15 minutes of arriving.
Yes — we work on gas appliances of any age provided parts are still available from the manufacturer. We’ll always advise honestly if an appliance is past economic repair or no longer safe to keep in service. Older gas fires (pre-1996) without oxygen depletion sensors are particularly worth assessing for safety before further use.
A gas tightness test (also called gas pressure test) checks the entire gas supply within your property to confirm there are no leaks. We isolate the meter, apply test pressure, and measure for pressure drop over a timed period. Any drop indicates a leak somewhere in the system. We perform a tightness test as part of any gas work, before and after, to ensure no leaks have been introduced or missed.
No, provided the work is done by a Gas Safe registered engineer using manufacturer-spec parts — both of which we always do. We register repairs against the appliance serial number where required so your warranty stays intact.
Yes — we offer annual service contracts for gas cookers, gas fires, gas water heaters and other gas appliances. Annual servicing identifies wear before failure, maintains efficiency, and provides documented records useful for landlord compliance and insurance. We can combine appliance servicing with a CP12 certificate for landlord properties.
Yes — flexible gas connectors (the corrugated stainless steel pipes connecting cookers to the gas supply) wear out over time and should be replaced periodically. We fit British Standard EN 14800 compliant flexible connectors with full safety testing. Old connectors with visible wear, kinks or surface damage should be replaced regardless of age.

4.9/5 from 134 verified Perth customers